Wednesday, January 11, 2023

Configuring the default gateway of a Layer 2 switch.

Question:

Configuring the default gateway of a Layer 2 switch.

Answer:

Enter global configuration mode.

S1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.

Configure 192.168.10.1 as the default gateway for S1.

S1(config)#ip default-gateway 192.168.10.1
S1(config)#

You have successfully set the default gateway on switch S1. 

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Explain the purpose of Data Link Layer and also draw the diagram for the same.

The Data Link layer is responsible for  Communications between end-device network interface cards. It allows upper layer protocols to access...

  • Navigate Between IOS Modes
    Que - Write commands to navigate between IOS command lines on a switch. Enter privileged EXEC mode using the  enable  command. Switch>...
  • Basic Device Configuration.
      Question - Secure management access to a switch. Assign a device name. Secure user EXEC mode access. Secure privileged EXEC mode access....
  • Data Communication Networking - Question Answer
    Theory Test - Sample Question Module 1: Networking Today - Click Here Module 3: Protocols and Models  -  Click Here Module 4 : Physical Lay...